Power off DiVA

From SpinetiX Support Wiki

Jump to: navigation, search
DiVA power consumption is so low that the player can be left running all the time - to save power, activate the display power saving because the display is consuming a lot more power than the player itself.

In order to safely disconnect the DiVA player from the power network, it is strongly recommended to follow these steps:

  1. Shut down the player, as described below.
    Note Warning:
    Unplugging the player from the power network without a prior shutdown, especially in a repetitive manner, could cause content loss and / or hardware problems.
  2. Wait until the player has shut down completely - the PWR LED is briefly blinking red once every two seconds.
  3. Unplug the power supply unit from the power network and / or the power supply cable from the player power port.

DiVA player can be shut down using one of the following methods:

Note Notes:
  • DiVA player has shut down completely when there is no signal on the displaying device and the PWR LED turns red and blinks slowly.
  • After DiVA player has been shut down, it can be started by briefly pressing its blue button or by physically reconnecting it to the electrical network.
This page was last modified on 4 February 2019, at 18:25.